Vector signal generator

0
294
Advertisement

In March 2012, Anritsu launched its MG3710A vector signal generator.

Features and USP: Up to two RF output connectors can be installed in MG3710A, each with two built-in waveform memories to output two combined modulation signals from each RF connector for a maximum of four modulation signal outputs. A single MG3710A can output wanted + interference, wanted + delay, multi-carrier and other signals, eliminating the cost of two normal generators while streamlining the measurement setup and operation times.

The MG3710A has a wide vector modulation signal band and large waveform memories while supporting digital modulation signals for a wide range of communications modulation technologies. Not only is it the ideal measurement solution for key mobile communications methods, such as mobile phones, wireless LAN, etc, but it also has the performance required for developing new wideband wireless communications.

For further details: Ph: +91 80 40581300; Fax: +91 80 40581301; [email protected]

Advertisement
SHARE
Previous articleParticle counter
Next articleLCR meter

SHARE YOUR THOUGHTS & COMMENTS

Please enter your comment!
Please enter your name here

Are you human? *