- The conformal coatings of the family ELPEGUARD® SL 1800 FLZ can be used flexibly both at high and low temperatures
- The group is a global leader in the field of electronics-related high-tech coatings for automotive electronics, aerospace engineering, industrial electronics, medical technology and LED applications
Peters Group has launched a wide range of new products at productronica. From coatings for the manufacture of printed circuit boards and the protection of assembled printed circuit boards/electronic components to integrated coating technology solutions, Peters is a global leader in the field of electronics-related high-tech coatings for automotive electronics, aerospace engineering, industrial electronics, medical technology, LED applications and other industries.
Check out the four new additions here:
New ELPEGUARD® thick film coating Twin-Cure® DSL 1602 FLZ/400 for rapid UV LED curing
These are much more effective and energy-saving than common mercury vapour lamps, cooler when operated, and their lifetime is by far longer. Since the harmful ozone and UVC loads are eliminated, there is a lower hazard for the operator. Based on a solids content of 100 %, this system prevents any solvent/VOC emission and thus minimises environmental impacts.
The thick film coating Twin-Cure® DSL 1602 FLZ/400 combines the excellent final properties of a polyurethane system (UR) with those of the rapid UV LED curing unsaturated polyacrylates (AR) in a 1-pack copolymer which is distinguished by a strong performance under mechanical, chemical and climatic loads and extreme changes of temperature.
High resistance against external impacts featured by the 2-pack conformal coatings of the series ELPEGUARD® SL 9407 FLZ
To resist extreme environmental influences such as corrosive gases, even at the highest severity level GX according to ANSI/ISA-71.04, electronics are protected with the resistant 2-pack conformal coatings of the series ELPEGUARD® SL 9407 FLZ. The protection also covers high moisture loads and temperature changes from -65 to 125 °C.
More than one-half of the substances formulated are renewable raw materials, while by the same token, the solvent emission is < 5 %. The conformal coatings of the series ELPEGUARD® SL 9407 FLZ contribute to a sustainable conformal coating process.
Permelastic synthetic rubber ELPEGUARD® UTC 1507 FLZ
The special strength of the cold-flexible conformal coating ELPEGUARD® UTC 1507 FLZ lies in its permanent high elasticity which is of particular importance under extreme temperatures from -65 to +150 °C. Conformal coating with ELPEGUARD® UTC 1507 FLZ enhances the reliability of operation of the electronics, even in a corrosive gas atmosphere of the highest severeness level GX in accordance with ANSI/ISA-71.04.
Among the further benefits of synthetic rubbers, there is a low permeability to water vapour and a low absorbance of moisture, as well as very good electrical insulation properties even under moisture, which are similar to those of silicones.
Cold-flexible acrylates of the conformal coating family ELPEGUARD® SL 1800 FLZ
The conformal coatings of the family ELPEGUARD® SL 1800 FLZ can be used both at high and low temperatures, thus allowing to increase the reliability and lifetime of electronic assemblies or optical components such as sensors exposed to moisture. These physically drying thin film coatings can be soldered through in case of repair, or removed by means of the dedicated thinner. A good crosslinking even of silicone-contaminated surfaces is achieved by the conformal coatings of the series ELPEGUARD® SL 1801 FLZ.
The productronica is the world’s leading international trade fair for innovative electronics production. It is the only event of its kind that covers the complete range of current and forward-looking products, technologies and system solutions in their entire breadth and depth and along the entire value-added chain.